Power Line Antenna

 

Scan and display all three states of power

Power Line Antenna hardware

The Power Line Antenna (PLA) covers the frequency range of 1 kHz to 50 MHz. When connected to a system containing a CTL-SystemWare Baseband Receiver, the combination provides the capability to scan and display phase, neutral and ground states of power from 1 kHz to 50 MHz in approximately one second.


Example Uses:

  • Scan three states of power
Three Phases of Power as output from PLA
  • Identify signals for analysis
Three Phases of Power as output from PLA

Features:

  • Portable and Lightweight
  • 1 kHz - 50 MHz Frequency Coverage
  • More than 10 Hours of Battery Life
  • Up to 64 dB of Attenuation
  • Automated Switching Between States of Power Via USB Control
  • Manual Switching for use with External Receiver or Spectrum Analyzer

Software:

  • Compatible with Resource Manager Software

Hardware:

  • Line Input: 0-264 VAC, 50/60 Hz
  • Input Connector: AC Line In
  • Output Connector: Two BNC ports, 50 Ohm
  • Bandwidth: 1kHz to 50 MHz
  • Gain: 18dB @ 0 Attenuation Setting
  • Noise Voltage: 23 dB nom.
  • Power Supply Voltage: 12VDC
  • Power Consumption: <4W
  • Filtering: High-Pass and Notch Filters Attenuate the AC Line Components More than 140 dB
  • Attenuation (software): 64 dB Attenuator, 1dB Steps
  • Attenuation (Manual): 0,10,20,40 dB Attenuator or Combination of Two Buttons
  • Manual Control: 3 Channels PN, PG, NG
  • USB Software Control: 3 Channels PN, PG, NG
  • Physical Size: 6” x 6.25” x 1.5”

 

 
 

Interested in learning more about CTL-SystemWare?

We'd like to hear from you.

CTL-SystemWare
7063 Columbia Gateway Drive, Suite 110
Columbia, MD 21046

[Phone]  410.579.1300
[Email] SWI-Support@sysware.com